237NetworkNOTE: This feature restores all wired and wireless network settings to the factory settingsNOTE: You can also reset the print server to its factory settings using Web Based Management1. Press Menu.2. Press p or q to display the Network option, and then press OK.3. Press p or q to display the Network Reset option, and then press OK.4. Follow the machine's instruction to reset the network settings.The machine will restart.Print the WLAN ReportRelated Models:Dell E514dw / Dell E515dwThe WLAN Report reflects your machine's wireless status. If the wireless connection fails, check the error code onthe printed report.1. Press Menu.2. Do one of the following:• Dell E515dw Press p or q to display the Print Reports option, and then press OK.• Dell E514dw Press p or q to display the Machine Info. option, and then press OK.3. Press p or q to select the WLAN Report option, and then press OK.4. Press StartThe machine will print the WLAN Report.Wireless LAN Report Error CodesRelated Models:Dell E514dw / Dell E515dwIf the Wireless LAN Report shows that the connection failed, check the error code on the printed report and refer tothe corresponding instructions in the table:Error Code Problem and Recommended SolutionsTS-01 The wireless setting is not activated, turn the wireless setting to ON.If a network cable is connected to your machine, disconnect it and turn the wireless setting of your machine toON.TS-02 The wireless access point/router cannot be detected.1. Check the following four points:• Make sure that the wireless access point/router is powered on.• Move your machine to an obstruction-free area, or closer to the wireless access point/router.• Temporarily place your machine within about 3.3 feet (one meter) from the wireless access point when youare configuring the wireless settings.• If your wireless access point/router is using MAC address filtering, confirm the MAC address of the Dellmachine is allowed in the filter.2. If you manually entered the SSID and security information (SSID/authentication method/encryptionmethod/Network Key), the information may be incorrect. Confirm the SSID and security information andenter the correct information as necessary.