Dell EMC PowerEdge R240 CHRH4 Installation And Service Manual

Also see for EMC PowerEdge R240: Installation and service manual

Option DescriptionLoad Legacy VideoOption ROMEnables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from the videocontroller. Selecting Enabled in the operating system does not support UEFI video output standards. This field isavailable only for UEFI boot mode. You cannot set the option to Enabled if UEFI Secure Boot mode is enabled.This option is set to Disabled by default.Dell Wyse P25/P45BIOS AccessEnables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled by default.Power CycleRequestEnables or disables the Power Cycle Request. This option is set to None by default.iDRAC Settings utilityThe iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable variousiDRAC parameters by using the iDRAC settings utility.NOTE: Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals.Device SettingsDevice Settings enables you to configure the below device parameters:• Controller Configuration Utility• Embedded NIC Port1-X Configuration• NICs in slotX, Port1-X Configuration• BOSS Card configurationDell Lifecycle ControllerDell Lifecycle Controller (LC) provides advanced embedded systems management capabilities including system deployment, configuration,update, maintenance, and diagnosis. LC is delivered as part of the iDRAC out-of-band solution and Dell system embedded UnifiedExtensible Firmware Interface (UEFI) applications.Embedded system managementThe Dell Lifecycle Controller provides advanced embedded system management throughout the lifecycle of the system. The Dell LifecycleController can be started during the boot sequence and can function independently of the operating system.NOTE: Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the operating system,see the Dell Lifecycle Controller documentation at Dell.com/poweredgemanuals.36 Pre-operating system management applications