Dell EMC ScaleIO Ready Node 14G Manual

Output similar to the following is displayed:Controller = 0Status = SuccessDescription = Add VD SucceededResultsThe VD was created successfully.After you finishContinue with the procedure that referred you to this topic.Create virtual devices for SSD with PERCCLIUse PERCCLI to create virtual devices (VDs) for SSDs on a ScaleIO Ready Nodeserver.Before you beginEnsure that the PERCCLI disk utility is installed.cd /opt/lsi/perccli/Use this procedure both for SSD for storage and SSD to be used to provide cachingacceleration. The VDs created on SSD are configured with Direct IO and write-through, but read-ahead is not enabled.Procedure1. Log in to the server.2. Create the VD:perccli64 /c0 add vd type=raid0 drives=: direct wtnoraExample:perccli64 /c0 add vd type=raid0 drives=32:0 direct wt norawhereEID andSlt are the Enclosure ID and Slot ID values, which in this exampleare 32:0.ResultsThe VD was created successfully.After you finishContinue with the procedure that referred you to this topic.Ensure virtual disk creation with PERCCLIUse the PERCCLI utility to ensure that a virtual device (VD) was created properly oneach disk.Procedure1. Log in to the server.Preparing Disks to add to a ScaleIO SDS54 Hardware Configuration and Operating System Installation Guide - Windows Servers