Dell Edge 3000 Installation And Operation Manual

Also see for Edge 3000 Series: Getting started guide Getting started guide Activation guide

Contents

Dell Edge 3000 Installation And Operation Manual Manual pdf 12 page image

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.FFCC caution:• Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority tooperate this equipment.• This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.Radiation exposure statement:This equipment complies with FCC radiation exposure limits for an uncontrolled environment. This equipment should be installed andoperated with a minimum distance of 20 cm between the active transceiver and your body.NOTE: The country code selection is for a non-US model only and is not available to all US model. Per FCC regulation, allWiFi products marketed in the US must be fixed to US operation channels only.Industry Canada statementThis device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:1. this device may not cause interference, and2. this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation estautorisée aux deux conditions suivantes:1. l'appareil ne doit pas produire de brouillage, et2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'encompromettre le fonctionnement.Under Industry Canada regulations, the radio transmitter(s) may only operate using an antenna(s) of a type and maximum (or lesser)gain approved for the transmitter(s). To reduce potential radio interference to other users, the antenna type(s) and gain(s) should bechosen so that the Equivalent Isotropic Radiated Power (E.I.R.P.) is not more than what was approved for the transmitter(s).This Class A digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.This device complies with RSS-210 of Industry Canada. Operation is subject to the condition that this device does not cause harmfulinterference.Cet appareil est conforme à la norme RSS-210 d'Industrie Canada. L'opération est soumise à la condition que cet appareil neprovoque aucune interférence nuisible.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, excepttested built-in radios.12