Dell Edge Gateway 3002 Installation And Operation Manual

Also see for Dell Edge Gateway 3002: Getting started guide Getting started guide Specifications Getting started guide Installation and operation manual

Contents

Dell Edge Gateway 3002 Installation And Operation Manual Manual pdf 50 page image

– Network settings (for example, proxy URL)Boot up and log in – Remote system configuration1. Connect a network cable from Ethernet port one on the Edge Gateway to a DHCP-enabled network or router that provides IPaddresses.2. In your network's DHCP server, use the command dhcp-lease-list to obtain the IP address associated with the EdgeGateway's MAC address.3. Setup as SSH session using an SSH terminal emulator (for example, native command-line ssh client on Linux or PuTTY onWindows).NOTE: The SSH service is enabled on Ubuntu Core 16 by default.4. Enter the command ssh admin@, followed by the default user name and password. The default user name andpassword are both admin.For example;lo@lo-Latitude-E7470:~$ ssh admin@10.101.46.209admin@10.101.46.209's password:Boot up and log in – Static IP system configurationThis allows you to connect your Edge Gateway through a host computer, which must be on the same subnet.NOTE: The static IP address of Ethernet port two on the Edge Gateway is set to these values at the factory:• IP address: 192.168.2.1• Subnet mask: 255.255.255.0• DHCP server: Not applicable1. On the host computer, configure the Ethernet adaptor that is connected to the Edge Gateway with a static IPv4 address underthe same subnet. Set the IPv4 address to 192.168.2.x (where x represents the last digit of the IP address, for example,192.168.2.2).NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between192.168.2.2 to 192.168.2.254.2. Set the subnet mask to 255.255.255.0.Updating operating system and applicationsAfter enabling the network connections and connecting to the internet, Dell recommends to have the latest OS components andapplications installed. To update Ubuntu Core 16, run:admin@localhost:~$ sudo snap refreshViewing operating system and application versionsRun the command:admin@localhost:~$ sudo uname –areturnsLinux ubuntu.localdomain 4.4.30-xenial_generic #1 SMP Mon Nov 14 14:02:48 UTC 2016 x86_64x86_64 x86_64 GNU/LinuxNOTE: Check if a newer version of the software is available. For more information on checking for updates, see Updatingoperating system and applications.50