Dell Equallogic PS6000 Hardware Maintenance

Also see for PS6000: Configuration guide Hardware Quick reference guide Overview Installation and setup manual

Dell Equallogic PS6000 Hardware Maintenance Manual pdf 33 page image

PS6000 Hardware Maintenance Maintaining Control Modules3–11Figure 3-5: Removing a Control Module3. Place the control module on a flat surface where it will be protected fromelectrostatic charge.Caution: To avoid damage, do not place anything on top of the control module.4. If you are replacing a failed control module, remove the micro SD card fromthe failed control module as described in Replacing the Micro SD Card onpage 3-14 and install it in the replacement control module. This will makesure that the new control module is running the correct firmware.To install a replacement control module, see Installing a Control Module onpage 3-11. Do not operate an array with an empty control module slot.When you replace a failed control module, return the module in the packaging inwhich the replacement module was shipped. Contact your PS Series supportprovider for information about returning hardware.Installing a Control ModuleYou can install a control module without shutting down the array.Caution: Do not mix control module types in a PS6000 array.