Dell External M620 t Owner's Manual

Also see for PowerEdge M620: Command reference guide Glossary Administrator's guide Hardware reference manual Information update

Contents

Dell External M620 t Owner's Manual Manual pdf 55 page image

5. Replace the hard drive(s)/SSDs.Ensure that you reinstall the hard drives/SSDs in their original locations.6. Reinstall the cooling shroud.7. Close the blade.8. Remove the plastic I/O connector covers from the back of the blade.9. Install the blade in the enclosure.10. Import your new or existing iDRAC Enterprise license. For more information, see theiDRAC7 User's Guide atsupport.dell.com/manuals.NVRAM Backup BatteryReplacing The NVRAM Backup BatteryWARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only withthe same or equivalent type recommended by the manufacturer. Discard used batteries according to themanufacturer's instructions. See the safety instructions that came with your system for additional information.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Remove the blade from the enclosure.2. Open the blade.3. Remove the system board to access the battery.4. To remove the battery, press down firmly on the positive side of the connector and lift the battery out of thesecuring tabs at the negative side of the connector.5. To install a new system battery:a) Support the battery connector by pressing down firmly on the positive side of the connector.b) Hold the battery with the "+" facing up and slide it under the securing tabs at the positive side of the connector.6. Press the battery straight down into the connector until it snaps into place.7. Reinstall the system board.8. Close the blade.9. Install the blade in the enclosure.10. Enter the System Setup to confirm that the battery is operating properly.11. Enter the correct time and date in the System Setup's Time and Date fields.12. Exit the System Setup.13. To test the newly installed battery, remove the blade for at least an hour.14. After an hour, reinstall the blade.15. Enter the System Setup and if the time and date are still incorrect, see Getting Help.55