Dell Force10 E300 Installing And Maintaining

Also see for Force10 E300: Configuration guide Quick start guide

Contents

Dell Force10 E300 Installing And Maintaining Manual pdf 58 page image

58 | Alarmsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mAC Power Supplies and AlarmsDuring system boot, if the redundant power supply (the fourth power supply) is missing or fails, theFTOS does not generate any alarm messages since the minimum configuration of three power supplies isoperating. Yet, if a fourth AC power supply is installed, and later one of the four power supplies isremoved or fails, the system generates a minor alarm and a message stating that the configuration is non-redundant (%CHMGR-1-MINOR_PS: Minor alarm: power supply non-redundant ).If only three power supplies are installed and one of them fails while the E300 System is operating, thesoftware generates a major alarm and an SNMP trap, lights the major LED, and activates the audiblealarm.Line Card Hardware failure major (red) major amber noExceeds high temperature limit major (red) major unlit yesExceeds warning temperature limit minor (amber) minor green yesIndividual interface fails minor (amber) reported ambera noRPM (Non-redundant Configuration with 1 RPM)Exceeds high temperature limit major (red) major unlit yesExceeds warning temperature limit minor (amber) minor green noRPM fails but CP is ok major (red) major amber yesSFMsExceeds high temperature limit major (red) major unlit yesExceeds warning temperature limit minor (amber) minor green noAny card fails major (red) major unlit yesAny card removed major (red) major unlit yesa. The interface’s Link LED is unlit.Table C-1. Alarm Events and Reporting (continued)Module Alarm Event Alarm LED Reported inevent logStatus LEDon ModuleAudibleAlarm?