Power Supplies | 29Replace an AC or DC power supplyNOTE: If a power supply fails, it must be completely replaced. There are no field servicable components inthe module itself. Refer to Chapter 9, Technical Support to request a hardware replacement.To replace a power supply, follow the steps below:2 Using the grab handle, slide the unit in to the power supply bay.3 Tighten the securing screw at the top of the unit.4 Attach power cables.5 The system powers up as soon as the cables are connected between the power supply and the power source.Step Task1 Disconnect the power cable from the power supply.2 Use the grab handle to slide the unit out of the power supply bay.NOTE: If the power supply is not going to be replaced, attach a blank panel to the power supply slot.3 Using the grab handle on the replacement unit, slide it into the power supply bay.4 Tighten the securing screws on the module with a screwdriver. Ensure that the module is secure.5 Attach power cord to the new module.6 The system powers up as soon as the cables are connected between the power supply and the power source.Step Task