Documentation http://support.dell.com/support/edocs/systems/ins5100/en/sm/display....5 of 6 2008-03-11 10:251 inverter connector2 bottom flex-cableconnector3 pull-tabInstalling the Display PanelConnect the top flex-cable connector to the display panel connector.1.Connect the bottom flex-cable connector to the inverter connector.2.Lay the display panel in the top cover.3.Route the display-feed flex cable so that it rests in the notch located in the bottomedge of the top cover.4.Replace the eight M2 x 3-mm screws that secure the display panel to the topcover.5.Replace the display bezel.6.Display Latch AssemblyRemoving the Display Latch AssemblyCAUTION: Before performing the following procedures, read the safetyinstructions in your Owner's Manual.CAUTION: To prevent static damage to components inside your computer,discharge static electricity from your body before you touch any of yourcomputer's electronic components. You can do so by touching anunpainted metal surface.Follow the instructions in "Preparing to Work Inside the Computer."1.Remove the keyboard.2.Remove the display assembly.3.Remove the display bezel.4.Remove the two M2.5 x 5-mm screws that secure the display latch assembly to thetop cover.5.Lift the display latch assembly up and out of the top cover.6.