4. Connect the display cable to the connector on the system board, and replace the display cable grounding screw.5. Route the Mini-Card antenna cables through the routing guides on the palm rest.6. Thread the Mini-Card antenna cables through the slot in the computer base.7. Turn the computer over and replace the two screws that secure the display assembly to the computer base.8. Route and connect the Mini-Card antenna cables (see step 5 in Replacing the Mini-Card).9. Replace the keyboard (see Replacing the Keyboard).10. Replace the power button panel (see Replacing the Power Button Panel).11. Replace the module cover (see Replacing the Module Cover).12. Replace the battery (see Replacing the Battery).Display BezelRemoving the Display Bezel1. Follow the procedures in Before You Begin.2. Remove the display assembly (see Removing the Display Assembly).3. Carefully pull up around the inside edges of the display bezel to remove it from the display assembly.Replacing the Display Bezel1. Follow the procedures in Before You Begin.2. Ensure the display cable and Mini-Card antenna cables run through the notch on the left hinge to keep the cables clear of the display bezel.3. Place the display bezel over the hinges first.4. Gently press down around the display bezel to snap it into place.CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.1 display bezel 2 display assembly