Replacing the stand assemblyWARNING: Before working inside your computer, read the safetyinformation that shipped with your computer and follow the steps inBefore working inside your computer. After working inside yourcomputer, follow the instructions in After working inside yourcomputer. For more safety best practices, see the RegulatoryCompliance home page at www.dell.com/regulatory_compliance.Procedure1 Place the stand assembly on the middle cover.2 Connect the touch screen cable to the middle cover.3 Route the cable through the routing clip.4 Adhere the tape over the touch screen cable.5 Turn the stand assembly over and slide the tabs on the stand assemblyinto the slots on the middle cover.6 Replace the screws that secure the stand assembly to the middle cover.7 Route all the cables through their routing guides.For more information, see Display panel with stand assembly.8 Replace the screws that secure the cables to the middle cover.9 Align the antenna modules with the alignment posts and adhere them tothe middle cover.10 Adhere the tapes that secure the cables to the middle cover.11 Slide the display cable into the display-cable connector slot and connectthe display cable to the middle cover.12 Replace the screws that secure the cables to the middle cover.13 Connect the power-button cable and control-buttons board cable to thecontrol-buttons board cable.14 Connect the converter-board cable to the converter board.Post-requisites1 Replace the microphones.2 Replace the camera.3 Replace the back cover.81