Removing the system boardWARNING: Before working inside your computer, read the safetyinformation that shipped with your computer and follow the steps in Beforeworking inside your computer. After working inside your computer, followthe instructions in After working inside your computer. For more safety bestpractices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.NOTE: Your computer’s Service Tag is stored in the system board. Youmust enter the Service Tag in the BIOS setup program after you replace thesystem board.NOTE: Replacing the system board removes any changes you have made tothe BIOS using the BIOS setup program. You must make the appropriatechanges again after you replace the system board.NOTE: Before disconnecting the cables from the system board, note thelocation of the connectors so that you can reconnect the cables correctlyafter you replace the system board.Prerequisites1 Remove the computer cover.2 Remove the front bezel.3 Remove the memory modules.4 Remove the wireless card.5 Remove the processor fan.6 Remove the heat sink.ProcedureNOTE: Note the routing of all cables as you remove them so that you canreroute them correctly after you replace the system board. For informationon system board connectors, see “System board components’.1 Disconnect the optical-drive data cable from the system board.2 Disconnect the hard-drive data cable from the system board.69