Dell Inspiron 500m Service Manual

Also see for Inspiron 600m: Setup guide User guide Setup guide Start here Start here

Contents

Dell Inspiron 500m Service Manual Manual pdf 18 page image

Back to Contents PageHard DriveDell™ Inspiron™ 500m Service Manual1. Follow the instructions in "Preparing to Work Inside the Computer."2. Turn the computer over. Use a standard #1 Phillips screwdriver to remove the M2.5 x 5-mm screw.3. Slide the hard drive out of the computer.4. Remove the new drive from its packaging.Save the original packaging to use when storing or shipping the hard drive.5. Open the display approximately 0.5 inch.CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.CAUTION: Before working inside your computer, read the safety instructions in your Owner's Manual.NOTICE: To prevent data loss, shut down your computer before removing the hard drive. Do not remove the hard drive while the computer is on, instandby mode, or in hibernate mode.NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive.NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.1 M2.5 x 5-mm screwNOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in yourOwner's Manual.NOTICE: If you do not open the display before you replace your hard drive, you might permanently scratch your display bezel.