190 Appendix3 When F2 = Setup, F12 = Boot Menu appears in the upper-rightcorner of the screen, press .If you wait too long and the operating system logo appears, continue towait until you see the Microsoft Windows desktop. Then, shut down yourcomputer and try again.The Boot Device Menu appears, listing all available boot devices.Each device has a number next to it.4 At the bottom of the menu, enter the number of the device that is to beused for the current boot only.For example, if you are booting to a USB memory key, highlight USBFlash Device and press .NOTE: To boot to a USB device, the device must be bootable. To ensure yourdevice is bootable, check the device documentation.Changing Boot Sequence for Future Boots1 Enter system setup (see "Entering System Setup" on page 185).2 Use the arrow keys to highlight the Boot Sequence menu option and press to access the menu.NOTE: Write down your current boot sequence in case you want to restore it.3 Press the up- and down-arrow keys to move through the list of devices.4 Press the spacebar to enable or disable a device (enabled devices havea checkmark).5 Press plus (+) or minus (–) to move a selected device up or down the list.Clearing Forgotten PasswordsCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions located in the Product Information Guide.1 Follow the procedures in "Before You Begin" on page 103.2 Remove the computer cover (see "Removing the Computer Cover" onpage 105).3 Locate the 3-pin password connector (PSWD) on the system board.NOTE: The location of the password connector may vary depending on the system.
