Dell Inspiron M5030 Service Manual

Also see for Inspiron M5030: Setup guide Setup guide Service manual

Back to Contents PageProcessor Heat SinkDell™ Inspiron™ N5020/M5030/N5030 Service ManualRemoving the Processor Heat SinkReplacing the Processor Heat SinkRemoving the Processor Heat Sink1. Follow the instructions in Before You Begin.2. Remove the battery (see Removing the Battery).3. Remove the keyboard (see Removing the Keyboard).4. Remove the palm rest (see Removing the Palm Rest).5. Remove the adhesive tape that secures the display cable to the processor heat sink.6. Disconnect the fan cable and the display cable from their connectors on the system board.7. In sequential order (indicated on the processor heat sink), loosen the four captive screws that secure the processor heat sink to the system board.8. Lift the processor heat sink off the system board.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the processorheat sink.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.NOTE: Make a note of the cable routing before disconnecting the cables.1 processor heat sink 2 fan cable connector3 display cable connectorNOTE: The appearance and number of screws on the processor heat sink may vary based on the your computer model.