Dell LATITUDE E6400 XFR Service Manual

Also see for Latitude E6400 XFR: System Board Replacement How-to guide Service manual Setup and features information Installation instructions

Contents

Dell LATITUDE E6400 XFR Service Manual Manual pdf 67 page image

Dell™ Latitude™ E6420 XFR Service ManualPage 6736.2 Replacing the Stylus1. Pinch the end of the tether loop to a point.2. Place the tether loop, pointed end first, through the tether anchor at the edge of the system.3. Run the stylus and tether through the tether loop.4. Once the stylus and tether are completely through the tether loop, pull the stylus to secure the tether looponto the tether anchor.5. Insert stylus in stylus bay below the handle6. Follow the procedures in After Working on Your Computer.37 Shoulder Strap Anchors37.1 Removing the Shoulder Strap AnchorsCAUTION: Before you begin any of the procedures in this section, follow the safetyinstructions that shipped with your computer.1. Follow the procedures in Before Working on Your Computer.2. Remove shoulder strap attached to should strap anchors if present.3. Remove the two M2.5x10 mm screws securing the left and right should strap anchors to the chassis..4. Remove the should strap anchors from the chassis.37.2 Replacing the Shoulder Strap Anchors1. Insert the left and right shoulder strap anchors into the chassis.2. Replace the two M2.5 x10 mm screws to secure each shoulder strap anchor to the chassis.3. Attach the shoulder strap to the anchors.4. Follow the procedures in After Working on Your Computer.38 Handle38.1 Removing the HandleCAUTION: Before you begin any of the procedures in this section, follow the safetyinstructions that shipped with your computer.1. Follow the procedures in Before Working on Your Computer.2. Remove the palm rest (see Removing the palm rest assembly3. Remove the shoulder strap anchors if present (See Removing Shoulder Strap Anchors).).