Dell LATITUDE XT2 XFR Service Manual

Also see for LATITUDE XT2 XFR: Setup and features information

Contents

Dell™ Latitude™ XT2 XFR Service ManualPage 66 of 94 Version A00-0110. Complete the assembly by performing Installing the palm rest.4.19 RF Passthru4.19.1 Removing the RF Passthru BoardWARNING: Before working inside your XT2 XFR, read the safety information thatshipped with your XT2 XFR. For additional safety best practices information, see theRegulatory Compliance Homepage at www.dell.com/regulatory_compliance.1. Follow the procedures in Before Working Inside Your XT2 XFR.2. Follow the procedures in removing the palm rest before continuing.3. Follow the procedures in Removing the system board before continuing.4. Remove the two (2.5 x 5-mm) screws holding the RF Passthru board onto the bottom chassis.5. Remove the WWAN and WLAN RF Cables from the retaining tab.6. Lift the RF Passthru board straight up to remove.4.19.2 Installing the RF Passthru Board1. Connect the Black/Grey, Red and Black antenna cables from the Display assembly to the RFPassthru board. The RF Passthru board barrel connectors are labeled for each cable.