Dell Latitude 2110 Quick Reference Manual

Also see for Latitude 2110: Setup & features Service manual Specifications

Contents

Dell Latitude 2110 Quick Reference Manual Manual pdf 7 page image

888-24-116-W-00 rev.A • 05/10ENGLISH7 / 32Cleaning and MaintenanceWARNING: Failure to observe the following safety notices may result in serious personal injury or equipment damage.Inspect for damage, dirt and debris on a regular basis. All paint and plastic components used in the MCS will withstand cleaning by most commonly used,diluted, non-abrasive solutions such as quaternary ammonia compounds, ammonia enzyme cleaners, bleach, or alcohol solutions. It is recommended that anycleaning solution be tested on a small, inconspicuous area to ensure it does not harm the surface of the MCS.• Marks from permanent marker, dry-erase marker, and pens can be removed with 91% isopropyl alcohol and a soft cloth.• Iodine stains can be removed with commonly used cleaners and a soft cloth.• Do not use steel wool or other abrasive materials that may damage the surface finish.ELECTRICAL: To avoid risk of electric shock, do not expose electrical components to water, cleaning solutions or other potentially corrosive liquids orsubstances.ELECTRICAL: Do not immerse MCS or MCS components in liquid or allow liquids to flow into the MCS. Wipe all cleaners off surface immediately using adamp cloth. Dry the surface thoroughly after cleaning.Ergonomics and Safety AlertsELECTRICAL: Do not use flammable cleaners on MCS surfaces.CAUTION: Adjustment, Service, Replacement - DO NOT attempt to adjust, service or replace any part of the MCS unless directed to do so throughErgotron-approved documentation (i.e. installation instructions). Only Ergotron, Inc. or an Ergotron-certified entity may adjust, service or replace MCScomponents. If any component on the MCS is missing or damaged, the MCS must not be used. Contact Ergotron immediately to request a replacement part.CAUTION: Casters - Check casters periodically to make sure they are clean and free of debris that would prevent smooth travel. Avoid moving MCS acrossuneven, dirty, or damaged surfaces.CAUTION: Customer Equipment- Make sure equipment is balanced and mounted securely to MCS. Contact Ergotron for information about moving MCScomponents.CAUTION: MCS must be periodically inspected for damage, and any broken parts replaced as necessary.NOTE: Cables - Keep cables organized on the MCS (a variety of solutions are provided with your MCS for this purpose). Route excess cables away frommoving components with cable clips. Contact Ergotron for more information.Parking the Dell Mobile Computing Station 2.0The Dell MCS can be anchored using the heavy duty security loop located at the back of the cart (near the cable management bay. )WARNING: Failure to observe the following safety notices may result in serious personal injury or equipment damage.CAUTION: Do not block the fans and vent openings. To prevent overheating, leave at least 127 mm (5-inch) clearancearound fans and vents.WARNING: Do not park the MCS in areas of heavy traffic.WARNING: Do not run cables through doorways, holes in ceilings, wall, or floors.WARNING: Do not run cables across hallways, classrooms, or other areas where they will be walked on.WARNING: Do not leave MCS unattended in areas where children have access.WARNING: Keep MCS doors closed and locked whenever it is unattended or parked for charging or storage.WARNING: Do not place heavy objects on the MCS. The maximum weight capacity of the top surface is 11.4 kg (25 lb) and lower shelf is 27.2kg (60 lb).WARNING: Do not use the MCS to store liquids or cleaning supplies.ELECTRICAL: Do not place MCS in close proximity to flammable liquids or gases.ELECTRICAL: Using an incompatible cable or improperly connecting the cable to the controller box may cause fire or equipment damage.