Dell Latitude 5280 Owner's Manual

Also see for Vostro 5480: Setup and specifications Technical guidebook Owner's manual Quick start guide Owner's manual

Contents

Dell Latitude 5280 Owner's Manual Manual pdf 8 page image

CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by itsedges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables haveconnectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect thecable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect acable, ensure that both connectors are correctly oriented and aligned.NOTE: The color of your computer and certain components may appear differently than shown in this document.To avoid damaging your computer, perform the following steps before you begin working inside the computer.1 Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.2 Turn off your computer.3 If the computer is connected to a docking device (docked), undock it.CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable fromthe network device.4 Disconnect all network cables from the computer.5 Disconnect your computer and all attached devices from their electrical outlets.6 Close the display and turn the computer upside-down on a flat work surface.NOTE: To avoid damaging the system board, you must remove the main battery before you service the computer.7 Remove the base cover.8 Remove the main battery.9 Turn the computer top-side up.10 Open the display.11 Press and hold the power button for few seconds, to ground the system board.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before openingthe display.CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface,such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface todissipate static electricity, which could harm internal components.12 Remove any installed ExpressCards or Smart Cards from the appropriate slots.Turning off your computerAfter working inside your computerAfter you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turning on yourcomputer.CAUTION: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not usebatteries designed for other Dell computers.1 Connect any external devices, such as a port replicator or media base, and replace any cards, such as an ExpressCard.2 Connect any telephone or network cables to your computer.CAUTION: To connect a network cable, first plug the cable into the network device and then plug it into the computer.3 Replace the battery.4 Replace the base cover.5 Connect your computer and all attached devices to their electrical outlets.6 Turn on your computer.8 Working on your computer