Carrier Docomo KDDI Softbank Telstra GenericUMTS Band1,5,6,8,9,19 TD-SCDMA Band 39LTE/WWAN Antenna Main (Tx/Rx) +Aux(Rx/GNSS)Main (Tx/Rx) +Aux(Rx/GNSS)Main (Tx/Rx) +Aux(Rx/GNSS)Main (Tx/Rx) +Aux(Rx/GNSS)Main (Tx/Rx) +Aux(Rx/GNSS)Operating SystemSupportWindows 8.1, 32/64bitsWindows 7, 32/64bitsWindows 10, 32/64bitsWindows 8.1, 32/64bitsWindows 7, 32/64bitsWindows 10, 32/64bitsWindows 8.1, 32/64bitsWindows 7, 32/64bitsWindows 10, 32/64bitsWindows 8.1, 32/64bitsWindows 7, 32/64bitsWindows 10, 32/64bitsWindows 8.1, 32/64bitsWindows 7, 32/64bitsWindows 10, 32/64bitsHost Interface Supported bothUSB 3.1 Gen 1/USB2.0Supported bothUSB 3.1 Gen 1/USB2.0Supported bothUSB 3.1 Gen 1/USB2.0Supported bothUSB 3.1 Gen 1/USB2.0Supported bothUSB 3.1 Gen 1/USB2.0Wired communicationsTable 37. Wired communicationsNetwork Adapter (NIC) - Intel SpecificationsIntel i219LM Gigabit Ethernet Controller Integrated on system boardExternal connector type RJ-45Data Rates 10/100/1000 MbpsController bus architecture PCI-e V1.1x1Power consumption (full operation per data rate connection speed) • 1000 Mbps: 542 mW• 100 Mbps: 264 mW• 10 Mbps: 306 mWPower consumption (standby operation) • WOL Disabled: 0mW (LAN disabled using BIOS)• No Link (w/ WOL): 0.13 mW (cable Disconnected)• 10 Mbps Idle (w/ WOL): 76 mW• 100 Mbps Idle (w/ WOL): 169 mWIEEE standards compliance 802.3, 802.3ab, 802.3u, 802.azBoot ROM Support Support boot from PXE option ROMNetwork Transfer Rate Full duplex at 10, 100, or 1000 Mbps and half duplex at 10 or 100Mbps.Operating Temp/Storage Temp 0C to 85C/-40C to 125C(storage)Operating Humidity 20% to 80% (non-condensing)Operating System Driver support Linux, Win7, Win8, Win10Manageability WOL, PXEManagement Capabilities Alerting AMT 11 / DASH 1.136 Engineering specifications