Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C540/C640 Service Manual1 rubber screw covers(6)5 M2 x 4-mm screws (5)2 M2.5 x 5-mm screws(6)6 display-feed flex cable3 display bezel 7 flex-cable retention bracket4 top cover 8 display panelRemoving the Display BezelNOTICE: Disconnect the computer and any attached devices from electrical outlets,and remove any installed batteries.NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or bytouching an unpainted metal surface on the computer.NOTICE: Read "Preparing to Work Inside the Computer" before performing thefollowing procedure.1. Remove the hard drive.2. Remove the display assembly.3. Use a plastic scribe to pry the six rubber screw covers out of the screw holes locatedon the front of the bezel.4. Remove the six M2.5 x 5-mm screws located on the front of the bezel.NOTICE: Carefully separate the bezel from the top cover to avoid damage to thebezel.5. Starting at the bottom of the display panel (by the Dell™ logo), use your fingers toseparate the bezel from the top cover by lifting the inside of the bezel while pushingin on the outside.Removing the Display PanelNOTICE: Disconnect the computer and any attached devices from electrical outlets,and remove any installed batteries.file:///F|/Service%20Manuals/Dell/Latitude/c540-640/display.htm (5 of 12) [2/28/2004 7:57:51 AM]