Dell Latitude E6400 XFR Service Manual

Also see for Latitude E6400 XFR: System Board Replacement How-to guide Service manual Setup and features information Installation instructions

Contents

Dell Latitude E6400 XFR Service Manual Manual pdf 56 page image

Dell ™ Latitude™ E6400 XFR Service ManualPage 561 JSC1 Smartcard connector 5 JBIO1 BIO reader connector2 JTP1 Touchpad connector 6 J1394 1394 cable connector3 JSNIF1 Wi-Fi sniffer connector 7 Multi-mode HD video connector4 JSPK1 Speaker connector26.2 Replacing the System Board AssemblyCAUTION: Before you begin any of the procedures in this section, follow the safetyinstructions that shipped with your computer.NOTICE: Ensure that any loose cables do not get caught beneath the system board.1. Replace the card cage to the system board, before installing into the computer (see Replacing the Card Cage).2. Replace the gasket for the multi-mode display port.3. Place the left-edge (VGA connector and USB/E-SATA Port) of the system board into the base of the computer,ensuring the system board fits through the VGA Panel, the gasket for the multi-mode HD video connector isset properly, and the cable for the smartcard assembly is not interfering.4. Connect the DC power cable to the bottom of the system board.5. Lay the system board into place and push down on the back-right corner of the system board to connect it tothe I/O card.6. Replace the eight M2.5 x 5-mm screws to the system board.7. Replace the two M2 x 3-mm screws for the card cage.8. Route and connect the 1394 card cable to the connector on the system board. Press down on the flat area ofthe cable to adhere it to the system board.9. Install the Wi-Fi sniffer cable to the system board.10. Connect the smartcard cable to the connector on the system board.11. Replace the SIM card assembly (see Replacing the SIM Card Assembly).12. Replace the palm rest, keyboard, palm rest overlay and LED cover (see Replacing the Palm Rest).13. Replace the modular drive (see Replacing the Modular Drive).14. Replace the hard drive (see Replacing the Hard Drive).15. Replace the processor, heatsink assembly, and fan (see Replacing the Processor Module).16. Replace the memory modules (see Replacing a Memory Module).17. Replace the mini-pci cards in the WPAN/UWB/FCM card slot, WLAN/WiMax card slot, and/or WWAN/FCM cardslot, if applicable (see Chapters 5, 6, 7 and 8 for replacement procedures).18. Replace the coin cell battery (see Replacing the Coin Cell Battery).19. If you are installing a new system board, make a note of the number on the yellow label, located on the insideof the bottom access panel. You will need this number when you first power on the computer for AMTprovisioning.