Dell Latitude E6410 Service Manual

Also see for Latitude E6410: Manual How-to guide How-to guide How-to guide How-to guide

Dell Latitude E6410 Service Manual Manual pdf 31 page image

Back to Removing and Replacing PartsIEEE 1394 PortDell™ Latitude™ E6410/E6410 ATG Service ManualRemoving the IEEE 1394 Port1. Follow the procedures in Before Working Inside Your Computer.2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).3. Remove the battery.4. Remove the SIM card.5. Remove the SD card.6. Remove the ExpressCard.7. Remove the Smart card.8. Remove the hinge covers.9. Remove the access panel.10. Remove the optical drive.11. Remove the hard drive.12. Remove the LED cover.13. Remove the keyboard.14. Remove the coin-cell battery.15. Remove the memory.16. Remove the WWAN card.17. Remove the WLAN card.18. Remove the Latitude On™ Flash/CMG module.19. Remove the Fingerprint Reader.20. Remove the Heat Sink and Processor Fan.21. Remove the Display Assembly.22. Peel back the Ferrite sheet covering the firewire cable.23. Disconnect and unthread the firewire data cable from the system board.24. Remove the screws that secure the IEEE 1394 board to the computer.25. Remove the IEEE 1394 board from the computer.Replacing the IEEE 1394 PortTo replace the IEEE 1394 port, perform the above steps in reverse order.Back to Removing and Replacing PartsWARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.