34 Troubleshooting Your ProjectorGuiding SignalsProjector Status DescriptionControl Buttons IndicatorPower Menu Others TEMP(Amber)LAMP(Amber)Standby mode Projector in Standby mode. Ready to power on. BLUEFlashing OFF OFF OFF OFFWarming upmodeProjector takes some time to warm up and poweron. BLUE BLUE BLUE OFF OFFLamp on Projector in Normal mode, ready to display animage.Note: The OSD menu is not accessed.BLUE BLUE OFF OFF OFFCooling mode Projector is cooling to shutdown. BLUE OFF OFF OFF OFFPower SavingmodePower Saving mode has been activated. Theprojector will automatically enter standby mode, ifan input signal is not detected in two hours.AMBERFlashing OFF OFF OFF OFFCooling beforePower Savingmode.The projector takes 60 seconds to cool down beforeentering Power Saving mode. AMBER OFF OFF OFF OFFProjector over-heatedAir vents might be blocked or ambient temperaturemay be above 35℃. The projector automaticallyshuts down. Ensure that the air vents are notblocked and that the ambient temperature is withinoperational range. If the problem persists, contactDell.OFF OFF OFF AMBER OFFLamp over-heatedThe lamp is over heated. The air vents may beblocked. The projector automatically shuts down.Turn the display on again after the projector coolsdown. If problem persists, contact Dell.BLUE OFF OFF AMBER OFFLamp driverover-heatedThe lamp driver is over heated. The air vents maybe blocked. The projector automatically shutsdown. Turn the display on again after the projectorcools down. If the problem persists, contact Dell.AMBER OFF OFF AMBER OFFFan breakdown One of the fans has failed. The projectorautomatically shuts down. If the problem persists,contact Dell. OFF OFF OFF AMBERFlashing OFFLamp driverbreakdownThe lamp driver has failed. The projectorautomatically shuts down. Unplug the power cableafter three minutes then turn the display on again. Ifthis problem persists, contact Dell.AMBERFlashing OFF OFF OFF AMBERFlashingColor WheelbreakdownColor wheel cannot start. The projector has failedand the projector automatically shuts down.Unplug the power cable after three minutes andturn on the projector.. If this problem persists,contact Dell.BLUE OFF OFF AMBERFlashingAMBERFlashingLamp failure Lamp is defective. Replace the lamp. OFF OFF OFF OFF AMBERFault - DCsupply (+12V)Power supply has been interrupted. The projectorautomatically shuts down. Unplug the power cableafter three minutes and then turn on the projector. Ifthis problem persists, contact Dell.AMBERFlashing OFF OFF AMBER AMBERFault - DCsupplies(secondary)Power supply has been interrupted. The projectorautomatically shuts down. Unplug the power cableafter three minutes and then turn on the projector. Ifthis problem persists, contact Dell.AMBERFlashing OFF OFF AMBER OFF*Others: control buttons on the control panel exept Power and Menuhttp://www.pureglare.com.au