Dell M410HD User Manual

Also see for M410HD: User guide Specifications Firmware upgrade guide

14 Using Your Projector3Using Your ProjectorTurning Your Projector OnNOTE: Turn on the projector before you turn on the source (computer, DVDplayer, etc.). The Power button light blinks blue until pressed.1 Remove the lens cap.2 Connect the power cord and appropriate signal cables. For information aboutconnecting the projector, see "Connecting Your Projector" on page 8.3 Press the Power button (see "Using the Control Panel" on page 18 to locate thePower button).4 Turn on your source (computer, DVD player, etc.)5 Connect your source to the projector using the appropriate cable. See"Connecting Your Projector" on page 8 for instructions to connect your sourceto the projector.6 By default, the input source of projector is set to VGA-In. Change the inputsource of projector if necessary.7 If you have multiple sources connected to the projector, press the Sourcebutton on the remote control or control panel to select the desired source. See"Using the Control Panel" on page 18 and "Using the Remote Control" onpage 21 to locate the Source button.Turning Your Projector OffNOTICE: Unplug the projector after properly shutting down as explained in thefollowing procedure.1 Press the Power button.NOTE: The "Press Power Button to Turn off Projector" message willappear on the screen. The message disappears after 5 seconds or you canpress the Menu button to clear it.2 Press the Power button again. The cooling fans continue to operate for 120seconds.