Dell Networking N2000 Series Manual

Also see for N2000 Series: Reference guide Configuration guide Firmware upgrade

Contents

Dell Networking N2000 Series Manual Manual pdf 10 page image

10 SCG1015 Dell Networking N2000 Series Configuration Guide2.7 Configure Jumbo MTU for all portsNote: If iSCSI optimization is enabled, flow control is automatically configured on all switch ports upondetection of an EqualLogic Array. Dell recommends also manually configuring this step.console(config)#system jumbo mtu 9216console(config)#exit2.8 Configure spanning tree portfast on edge portsNote: If iSCSI optimization is enabled, spanning tree portfast is automatically configured on portsconnected to EqualLogic arrays. These manual steps must be performed on switch ports connected tohosts servers.console#configureconsole(config)#interface range gigabitethernet allconsole(config-if)#spanning-tree portfastconsole(config-if)#exit2.9 Configure 10GbE ports for LAGThese commands assign the two fixed 10GbE SFP+ ports on the front of the switch to the Port Channel.console(config)#interface range tengigabitethernet 1/0/1-2console(config-if)#no spanning-tree portfastconsole(config-if)#channel-group 1 mode activeconsole(config-if)#exitconsole(config)#exit2.10 Save configurationconsole#copy running-config startup-configThis operation may take a few minutes.Management interfaces will not be available during this time.Are you sure you want to save? (y/n)y