Dell Networking N4032 Configuration Manual

Also see for Networking N4032: Reference guide Configuration guide Configuration guide Getting started guide Getting started guide

Dell Networking N4032 Configuration Manual Manual pdf 27 page image

27 Stacking Dell Networking Switches: N4032, N4032F, N4064, N4064F2.3.2 Web interface methodThe example below shows how to add a stack member to an existing stack using the Web user interface.Before cabling an additional member to a stack, perform the steps below to setup the switch to join thestack. Once configured, continue to follow the instructions for cabling to complete the task. This worksbest when adding one stack member at a time. If multiple new members are to be added, follow thesedirections and complete the install of one before going to the next. Complete these steps again for eachremaining switch to be added.Selecting System > Stack Management > Stack Summary shows the current configuration before adding anew member.Note: The example given below allows a new member to be added without preconfiguring the existingstack, though each new member itself needs to be configured. To preconfigure a stack beforeconnecting the new stack member, consult theUser Guide underPreconfiguring a Stack Member.On the first new member switch to be added to the stack, select System > Stack Management > Stack PortSummary from the main navigation menu. In this example, two 40G QSFP+ interfaces F01/0/1 andF01/0/2 will be used for stacking, though any of the interfaces shown may be used.Be sure to configure enough stack ports to connect to two other switches if using a ring topology stack,to allow connections to switches in both directions.