Dell Networking N4032 Getting Started Manual

Also see for N4000 Series: Reference guide Reference guide Configuration guide Configuration guide Getting started guide

Dell Networking N4032 Getting Started Manual Manual pdf 26 page image

24 Starting and Configuring the SwitchExample SessionThis section describes an Easy Setup Wizard session. The following values areused by the example session:NOTE: There is no username, password, or ip address when the switch is unboxedor set to factory defaults.• SNMP is not enabled.• The default user name, root, is accepted and a password of admin123 isentered. The Wizard does not display the password as it is entered.• The OOB management interface uses 192.168.2.1 for IP addressassignment.NOTE: In the example below, the possible user options or default values areenclosed in [ ]. If you press with no options defined, the default value isaccepted. Help text is in parentheses.The following example contains the sequence of prompts and responsesassociated with running an example Dell Easy Setup Wizard session, usingthe input values listed above.After the switch completes the POST and is booted, the following text isdisplayed:(Unit 1-Waiting to select management unit)>Applying Global configuration, please wait...Welcome to Dell Easy Setup WizardThe Setup Wizard guides you through the initial switchconfiguration, and gets you up and running as quicklyas possible. You can skip the setup wizard, and enterCLI mode to manually configure the switch. You mustrespond to the next question to run the setup wizardwithin 60 seconds, otherwise the system will continuewith normal operation using the default systemconfiguration. Note: You can exit the setup wizard atany point by entering [ctrl+z].Would you like to run the setup wizard (you mustanswer this question within 60 seconds)? [Y/N] y