8Agency ComplianceUSA Federal Communications Commission (FCC) StatementThis equipment has been tested and found to comply with the limits for a Class A digital device, under Part 15 of the FCCrules. These limits are designated to provide reasonable protection against harmful interference when the equipment isoperated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it isnot installed and used in accordance to the instructions, it may cause harmful interference to radio communications.Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will berequired to take whatever measures necessary to correct the interference at their own expense. Properly shielded andgrounded cables and connectors must be used in order to meet FCC emission limits. Dell Networking is not responsiblefor any radio or television interference caused by using other than recommended cables and connectors or byunauthorized changes or modifications in the equipment. Unauthorized changes or modification could void the user’sauthority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:• This device may not cause harmful interference• This device must accept any interference received, including interference that may cause undesired operationCanadian Department of Communication StatementEuropean Union EMC Directive Conformance StatementThis product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximationof the laws of the Member States relating to electromagnetic compatibility. Dell Networking cannot accept responsibilityfor any failure to satisfy the protection requirements resulting from a nonrecommended modification of this product,including the fitting of non-Dell option cards.This product has been tested and found to comply with the limits for Class A Information Technology Equipmentaccording to CISPR 22/European Standard EN 55022. The limits for Class A equipment were derived for commercial andindustrial environments to provide reasonable protection against interference with licensed communication equipment.WARNING: This is a Class A product. In a domestic environment, this device may cause radio interference, inwhich case, you may be required to take adequate measures.45