To enter the System Setup, press immediately after a power-on or reboot.1. In the System BIOS or System Setup screen, select System Security and press .The System Security screen is displayed.2. In the System Security screen, verify that Password Status is Unlocked.3. Select System Password, alter or delete the existing system password and press or .4. Select Setup Password, alter or delete the existing setup password and press or .NOTE: If you change the System and/or Setup password, re-enter the new password when promoted. If youdelete the System and/or Setup password, confirm the deletion when promoted.5. Press and a message prompts you to save the changes.6. Press to save the changes and exit from the System Setup.The computer reboots.Disabling a System PasswordThe system's software security features include a system password and a setup password. The password jumperdisables any password(s) currently in use.NOTE: You can also use the following steps to disable a forgotten password.1. Follow the procedures inBefore Working on Your Computer.2. Remove the cover.3. Identify the PSWD jumper on the system board.4. Remove the PSWD jumper from the system board.NOTE: The existing passwords are not disabled (erased) until the computer boots without the jumper.5. Install the cover.NOTE: If you assign a new system and/or setup password with the PSWD jumper installed, the systemdisables the new password(s) the next time it boots.6. Connect the computer to the electrical outlet and power-on the computer.7. Power-off the computer and disconnect the power cable from the electrical outlet.8. Remove the cover.9. Replace the PSWD jumper on the system board.10. Install the cover.11. Follow the procedures inAfter Working on Your Computer.12. Power-on the computer.13. Go to the system setup, and assign a new system or setup password. SeeSetting up a System Password.50
