Dell OptiPlex 9010 Owner's Manual

Also see for OptiPlex 7010: Setup and features information Owner's manual Owner's manual Specifications Owner's manual

Contents

Error Message DescriptionPlug and play configuration error The computer encountered a problem while trying to configure one or morecards.Read fault The operating system cannot read from the floppy or hard drive, the computercould not find a particular sector on the disk, or the requested sector isdefective.Requested sector not found The operating system cannot read from the floppy or hard drive, the computercould not find a particular sector on the disk, or the requested sector isdefective.Reset failed The disk re-set operation failed.Sector not found The operating system cannot locate a sector on the floppy or hard drive.Seek error The operating system cannot find a specific track on the floppy disk or harddrive.Shutdown failure A chip on the system board might be malfunctioning.Time-of-day clock stopped The battery might be dead.Time-of-day not set-please run theSystem Setup programThe time or date stored in System Setup does not match the computer clock.Timer chip counter 2 failed A chip on the system board may be malfunctioning.Unexpected interrupt in protectedmodeThe keyboard controller may be malfunctioning or a memory module may beloose.WARNING: Dell's Disk MonitoringSystem has detected that drive [0/1] onthe [primary/secondary] EIDEcontroller is operating outside ofnormal specifications. It is advisable toimmediately back up your data andreplace your hard drive by calling yoursupport desk or Dell.During initial startup, the drive detected possible error conditions. When yourcomputer finishes booting, immediately back up your data and replace yourhard drive (for installation procedures, see "Adding and Removing Parts" foryour computer type). If no replacement drive is immediately available and thedrive is not the only bootable drive, enter System Setup and change theappropriate drive setting to None. Then remove the drive from the computer.Write fault The operating system cannot write to the floppy or hard drive.Write fault on selected drive The operating system cannot write to the floppy or hard drive.56