Dell OptiPlex 980 — Desktop Service Manual

Also see for OptiPlex 980 - Desktop: Specifications Setup & features Technical guidebook Technical guidebook Administrator's guide

Contents

Dell OptiPlex 980 — Desktop Service Manual Manual pdf 19 page image

Back to Contents PageDiagnosticsDell™ OptiPlex™ 980 Service Manual—DesktopDell DiagnosticsPower Button Light CodesBeep CodesDiagnostic LightsDell DiagnosticsWhen to Use the Dell DiagnosticsIt is recommended that you print these procedures before you begin.NOTE: The Dell Diagnostics software works only on Dell computers.NOTE: The Drivers and Utilities media is optional and may not ship with your computer.Enter system setup (see Entering System Setup), review your computer's configuration information, and ensure that thedevice you want to test displays in System Setup and is active.Start the Dell Diagnostics from either your hard drive or from the Drivers and Utilities media.Starting the Dell Diagnostics From Your Hard Drive1. Turn on (or restart) your computer.2. When the DELL logo appears, press immediately.NOTE: If you see a message stating that no diagnostics utility partition has been found, run the Dell Diagnostics fromyour Drivers and Utilities media.If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft®Windows® desktop. Then shut down your computer and try again.3. When the boot device list appears, highlight Boot to Utility Partition and press .4. When the Dell Diagnostics Main Menu appears, select the test that you want to run.Starting the Dell Diagnostics From the Drivers and Utilities Disc1. Insert the Drivers and Utilities disc.2. Shut down and restart the computer.When the DELL logo appears, press immediately.If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop. Then shutdown your computer and try again.NOTE: The next steps change the boot sequence for one time only. On the next startup, the computer boots accordingto the devices specified in the system setup program.3. When the boot device list appears, highlight Onboard or USB CD-ROM Drive and press .