6. If you are installing a drive that has its own controller card, install the controller card in a card slot.7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.8. If the CD/DVD drive bay was previously empty, remove the front-panel inserts.9. Close the computer cover.10. Attach the computer stand (optional).11. Connect your computer and devices to their electrical outlets, and turn them on.See the documentation that came with the drive for instructions on installing any software required for drive operation.12. Update your configuration information by setting the appropriate Drive option (0 or 1) under Drives: Secondary to Auto. See "Drive Configuration" formore information.After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the nextcomputer start-up:ALERT! Cover was previously removed.13. Reset the chassis intrusion detector by changing Chassis Intrusion to Enabled or Enabled- Silent.14. Verify that your computer works correctly by running the Dell Diagnostics.Back to Contents Page1 power cable2 audio cable3 CD/DVD drive cable4 IDE2 connectorNOTICE: To connect a network cable, first plug the cable into the network wall jack, and then plug it into the computer.NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusiondetector.
