Dell POWEREDGE 4300 Service Manual
Also see for POWEREDGE 4300: Rack installationRack installationUpgrade guideUpgrade guideInstallation guide
                                                                                                        | |
Contents
| 
Removing and Replacing Parts 4-7([WHUQDOO\$FFHVVLEOH'ULYHVThe chassis provides three bays for 5.25-inch externally accessible drives and abay dedicated to a 3.5-inch diskette drive.)URQW3DQHO,QVHUWV)LJXUH)URQW3DQHO,QVHUWVTo remove the front-panel insert that covers an unused bay (see Figure 4-5),first remove the front bezel. Then, facing the inside of the front bezel, pressone of the securing tabs (located at each end of the bezel) while pressingagainst the center of the insert until it springs free from the bezel.To replace a front-panel insert, from inside the chassis place the insert into thebay opening and press it into place until the tabs on each end of the insertsnap into the latches on the inside of the bezel.&ORVH2XW3DQHOVMetal close-out panels that fit into the drive-bay openings in the chassis pro-vide extra EMI shielding if you are not using the plastic front-panel inserts. Theclose-out panel for a 1.6-inch bay has a raised lip at the bottom that overlapsthe top of a panel beneath it, if any. Because of the overlap, if two or more1.6-inch close-out panels are installed, you must remove them from the topdown. The close-out panel for the 1-inch diskette-drive bay (the top bay ineither chassis orientation) is narrower and has no overlap lip.front-panelinserts |
Related manuals for Dell POWEREDGE 4300
Dell PowerEdge 4350 Service Manual
Dell PowerEdge 2300 Service Manual
Dell PowerEdge 4200 Service Manual
Dell PowerEdge 2650 Service Manual
Dell POWEREDGE 6350 Service Manual
Dell PowerEdge 4300 User Manual
Dell PowerEdge 1600SC Service Manual
Dell PowerEdge SE400 Manual
Dell PowerEdge 4600 Manual
Dell PowerEdge 4600 Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine