Dell POWERVAULT NX200 Hardware Owner's Manual

Also see for PowerVault NX200: Manual Getting started guide Troubleshooting guide Information update Setting up

Contents

Installing System Components 117Figure 3-20. Replacing the System Battery4 Remove the PCIe expansion card from slot 1. See "Removing anExpansion Card" on page 107.5 Locate the battery socket. See "System Board Connectors" on page 152.CAUTION: To avoid damage to the battery connector, you must firmly support theconnector while installing or removing a battery.6 Support the battery connector by pressing down firmly on the positive sideof the connector.7 Press the battery toward the positive side of the connector and lift it up outof the securing tabs at the negative side of the connector.8 Install the new battery by pressing down firmly on the positive sideof the connector.9 Hold the battery with the "+" facing up, and slide it under the securingtabs at the positive side of the connector.10 Press the battery straight down into the connector until it snaps into place.11 Install the expansion card. See "Installing an Expansion Card" on page 104.12 Install the expansion card stabilizer. See "Installing the Expansion CardStabilizer" on page 81.1 positive side of battery connector 2 system battery3 negative side of battery connector231