6 InstallationBefore installing the device, verify that the site selected for the device meets the following siterequirements:• Power — The device is installed within 1.5 m (5 feet) of a grounded, easily accessible outlet 220/110VAC, 50/60 Hz.• General — Ensure that the power supply is correctly installed.• Clearance — There is adequate frontal clearance for operator access. Allow clearance for cabling,power connections, and ventilation.• Cabling — Cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcastamplifiers, power lines, and fluorescent lighting fixtures.• Ambient Requirements — The ambient device operating temperature range is 0 to 45 °C (32 to113 °F) at a relative humidity of up to 95%, non-condensing. Verify that water or moisture cannot enterthe device case.UnpackingPackage ContentsWhile unpacking the device, ensure that the following items are included:• The device• AC power cable• Self-adhesive rubber pads (for on-shelf installation)• Rack-mount kit for installation• Documentation CD• Product Information GuideUnpacking the DeviceTo unpack the PowerConnect device:NOTE: Before unpacking the device, inspect the packaging and report any evidence of damage.1 Place the box on a clean flat surface.2 Open the box or remove the box top.3 Carefully remove the device from the package and place it on a secure, stable and clean surface.4 Remove all packing material.5 Inspect the product for damage. Report any damage immediately.
