PowerConnect 3324/3348 Release NotesConsole port speed not displayed with"show line console command"Console speed not displayed when "show line console" command is entered fromthe CLI interface.Port MirroringTitle DescriptionGigabit ports mirroring in stacking mode In cases where both source and destination ports are Gigabit ports, some of thepackets may be dropped due to the stacking management traffic.Tagged traffic in port mirroring All traffic on the mirroring target port is always tagged (even if originally it was sentuntagged).Mirroring of PAUSE frames Destination port does not receive PAUSE frames.Broadcast Storm ControlTitle DescriptionStorm control on G2 port Since the G2 stacking port is used for internal management traffic, storm control isdisabled on the G2 stacking port.Link Aggregation (LAG)Title DescriptionJoining a port to a LAG Joining a port to a LAG is possible only if:••••••••There is no Layer 3 interface defined on the port.The port does not belong to any VLAN.The port does not belong to any other LAG.The port is not a mirrored port.The port 802.1p priority is equal to LAGs 802.1p priority.An ACL is not defined on the port.QoS Trust is disabled on the port.GVRP is not enabled on the port.Port in LAG MAC addresses learning When a port is a member of LACP LAG under traffic, MAC addresses are learnedon the port until it actually joins to the LAG.Rapid Spanning Tree (RSTP)Title DescriptionRSTP port roles indications The command show spanning-tree interface does not show RSTP port roles, nor doesthe Web-based management.Layer3IPTitle DescriptionPing to self PowerConnect 3348/3348 cannot ping itself.QoS/ACLQoSTitle DescriptionChanging priority-queue commandcancels wrr-bandwidth settingsChanging the priority-queue out num-of-queues command value leaves any existingwrr-bandwidth commands.Editing ACL from CLI Once an ACL is bound to an interface it cannot be edited from the CLISystem Firmware Version 1.1.0.42 Page 6