Dell PowerConnect 3424 Release Notes

Also see for PowerConnect 3424: User guide Cli reference guide Specifications

Contents

PowerConnect 3424/3448 Release NotesSystem Firmware Version 2.0.0.20 Subject to Change Without Notice Page 5Viewing Statistics Æ ViewingRMON Statistics Æ Viewing RMONHistory TableOversize Packets – Number of oversized packets (over 1632 octets)received on the interface since the device was last refreshed.Jabbers – The number of packets received during this sampling intervalthat were longer than 1632 octets (excluding framing bits but includingFCS octets), and had either a bad Frame Check Sequence (FCS) with anintegral number of octets (FCS Error) or a bad FCS with a non-integralnumber of octets (Alignment Error).Dropped Events – counter is not supported.(and not as indicated)Corrections and Additions to the CLI Reference GuideCLI Command Description of ChangeCopy The range of the source-url and destination-url in the command copysource-url destination-url should be 1 – 128 characters.spanning-tree pathcost methodIn the command spanning-tree pathcost method {long | short}, longspecifies that defaults are per long pathcost method, and short specifiesthat defaults are per short pathcost method.The default path cost for interface are per the path cost method specified.The following indicates default path cost per method selected:Interface Long Method Short MethodPort-channel 20,000 4Gigabit EthernetPort20,000 4Fast Ethernet Port 200,000 19Ethernet (10 Mbps) 2,000,000 100spanning-tree portfastSyntax is changed to:spanning-tree portfast [auto]auto – Specifies that the software waits for three seconds (with no BPDUsreceived on the interface) prior to transitioning the interface to PortFastmode.The default mode is auto.service cpu-utilization By default, the cpu-utilization collection is enabled.switchport access vlanAn interface can only be assigned to "dynamic VLAN" if it is not a memberof any VLAN except the default VLAN.An interface can be assigned to "dynamic VLAN" only if it is in accessmode. Note that the default port mode for all ports is "access".switchport general allowed vlanswitchport general pvidshow vlanWhen an interface in General Mode is configured with a PVID, thisinterface is not automatically added as a member of the VLAN with thatVID.show vlan mac-to-vlan Syntax of command is “show vlan mac-to-vlan” and not as documented.power inline The syntax of the command is not as written, and should be power inline[auto | never]

/ 9

Related manuals for Dell PowerConnect 3424