Dell PowerConnect 6224 Release Note

Also see for PowerConnect 6224: Configuration guide User guide Command line interface guide Specifications Planning and preparation guide

Contents

18 System Firmware Version 3.2.0.6Description User Impact ResolutionBridge multicast forbiddenforward-unregistered causesL3 Multicast to fail.Flooding in ingress VLAN. Modified the L3 interaction code ofsnooping to notify the driver whensnooping is enabled. Whensnooping is disabled, the currentoperational state of snooping is alsosent to the driver.Cut-through mode commandhelp is not clear.For normal command and no commandthe help information is the same.Changed the help informationConsole logging levels helpdoes not indicate precedence.Help content needs to show severity levelof logging.Added the severity levels to the helpstrings.Web Dot1x Authentication MaxUsers show units in secondsvs. # Users.Incorrect help string added in read-onlypage of dot1x, causing user confusion.Removed help string for read-onlypage of dot1x.Web and CLI disagreement onDot1x statistics.Not displaying the MAC address correctlyin the field Last Frames Source in theweb page EAP Statistics.Corrected the problem in the objecthandler.ReFormatFlashFileSystem noavailable via the boot menu.ReFormatFlashFileSystem cannot beexecuted from boot menu.The ReFormatFlashFileSystemoperation is now available via theboot menu.Show interfaces advertiseethernet command is not parsedproperly.Show interfaces advertise ethernet command is not parsed properly.Added a check for invalid interface.Stack port link status mismatchin CLI and Web interface whenconfigured for Ethernet.To display the correct link status whenconfigured stack mode is Ethernet in theStack Port Summary web page.Corrected the web page to properlyhandle Ethernet and show linkstatus as up.Web Home > General > Assetselection does not showdetails.Incorrect link for Asset page on GeneralIndex page.Corrected the file name for theAsset page.Mirroring port should not sendCDP packets. Both mirrored and mirroring ports aresending CDP packets.Get probe events, and markinterface as acquired in ISDPdatabase. As a result, ISDP doesnot participate on this port.Backups with SNMP do notwork correctly.The MIB allows users to backup thestarting configuration to TFTP usingSNMP, but the file is corrupted.Corrected handling of uploadfiletypes and setting local filenamein SNMP.END command with all uppercase is not understood by CLI. User will not be able to go to root modeby entering END.Use case insensitive comparison.Trying to add ninth member toa channel-group shows LACPassignment in HTTP view.Trying to add ninth member to a channel-group shows LACP assignment in HTTPview.Corrected the code to enable LACPafter ports are added to lagsuccessfully.Switchport protected nameaccepts non-alphanumericcharacters.Needed to check that protected port nameaccepts only alphanumeric characters.Enhanced the validation.Description inconsistencybetween HTTP and CLIAdministration.Spaces were not accepted in descriptionfields through web.Added appropriate validation.Inconsistent CLI and Webinterface responses for STPLAG settings.Inconsistent CLI and Web interfaceresponses for STP LAG settings.Use the CLI formatting such thatboth the CLI and Web are in sync.Ip host parse Some ip host names with numbers andperiods are rejected.Corrected the host name checks.