Getting Started Guide 15Step 4:Finally, setup the default gateway. Please enter the IP address ofthe gateway from which this network is reachable. [0.0.0.0]:This is the configuration information that has been collected:SNMP Interface = "public"@192.168.2.100User Account setup = adminPassword = ********Management IP address = 192.168.2.1 255.255.255.0Default Gateway = 0.0.0.0Operation Mode = NormalStep 5:If the information is correct, please select (Y) to save theconfiguration, and copy to the start-up configuration file. If theinformation is incorrect, select (N) to discard configuration andrestart the wizard: [Y/N] yThank you for using Dell Easy Set up Wizard. You will now enter CLImode.Advanced ConfigurationThis section provides summary information about such common tasks as:• Retrieving an IP Address From a DHCP Server• Security Management and Password ConfigurationNOTE: For detailed information on all the CLI commands available for the 8024 and 8024F M6348switches, see the CLI Reference Guide.Retrieving an IP Address From a DHCP ServerWhen using the DHCP protocol to retrieve an IP address, the switch acts as a DHCP client.To retrieve an IP address from a DHCP server, perform the following steps:1 Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, inorder to retrieve the IP address.NOTE: You do not need to delete the switch configuration to retrieve an IP address for the D HCP server.2 Enter the following commands to use the selected port for receiving the IP address.console#configconsole(config)#ip address dhcpThe interface receives the IP address automatically.
