Configuring DHCPv6 Server and Relay Settings 1105Configuring the DHCPv6 Server and Relay (CLI)This section provides information about the commands you use to configureand monitor the DHCP server and address pools. For more information aboutthe commands, see thePowerConnect 8024/8024F/8132/8132F/8164/8164FCLI Reference Guide at support.dell.com/manuals.Configuring Global DHCP Server and Relay Agent SettingsBeginning in Privileged EXEC mode, use the following commands toconfigure settings for the DHCPv6 server.Configuring a DHCPv6 Pool for Stateless Server SupportBeginning in Privileged EXEC mode, use the following commands to create apool and configure pool parameters for DHCPv6 clients that obtain IPv6network information dynamically.Command Purposeconfigure Enter Global Configuration mode.service dhcpv6 Enable the DHCPv6 server.ipv6 dhcp relay-agent-info-optoptionConfigure a number to represent the DHCPv6 RelayAgent Information Option.Theoption parameter is an integer from 54–65535.ipv6 dhcp relay-agent-info-remote-id-suboptsuboptionConfigure a number to represent the DHCPv6 remote-IDsub-optionThesuboption parameter is an integer from 1–65535.exit Exit to Privileged EXEC mode.show ipv6 dhcp Verify the global DHCPv6 server configuration.Command Purposeconfigure Enter Global Configuration mode.ipv6 dhcp poolname Create a DHCPv6 pool and enter DHCPv6 poolconfiguration mode.dns-serveripv6-address Set up to 8 IPv6 DNS server addresses to provide to aDHCPv6 client by the DHCPv6 server.
