Dell PowerConnect J-Series J-SRX100 Services GatewayQuick StartUse the instructions in this quick start to help you connect the Dell PowerConnectJ-Series J-SRX100 Services Gateway to your network. For details, see the J-SRX100Services Gateway Hardware Guide at http://www.support.dell.com/manuals.(Regulatory model number SRX100)J-SRX100 Services Gateway Front PanelJ-SRX100 Services Gateway Back PanelJ-SRX100 Services Gateway ModelsThe following models of J-SRX100 Services Gateway are available:Connecting and Configuring the J-SRX100 Services GatewayUse the instructions below to connect and set up the J-SRX100 Services Gateway toprotect your network. Refer to the LEDs on the front panel of the device to help youdetermine the status of the device.Part 1: Connect the Services Gateway to Earth Ground1. Obtain a grounding cable—14 AWG single-strand, 4 A—with a ring-type,vinyl-insulated TV14-6R lug or equivalent attached by a licensed electrician.2. Connect the grounding cable to a proper earth ground.3. Place the grounding cable lug over the grounding point on the middle rear of thechassis, and secure the lug with one M3 screw.Part 2: Connect the Power Cable to the DeviceConnect the power cable to the device and a power source. We recommend using asurge protector. Note the following indications: POWER LED (green): The device is receiving power. STATUS LED (green): The device is operating normally. ALARM LED (amber): The device is operating normally, and may glow amber as arescue configuration has not been set. This is not a panic condition.NOTE: After a rescue configuration has been set, an amber ALARM LED indicates aminor alarm, and a solid red ALARM LED indicates that a major problem exists on theservices gateway.NOTE: You must allow the device between 5 and 7 minutes to boot up after you havepowered it on. Wait until the STATUS LED is solid green before proceeding to the nextpart.Callout Description Callout Description1 Power button 4 USB port2 LEDs (ALARM, POWER, STATUS, HA) 5 Console port3 Reset Config button 6 Fast Ethernet portsCallout Description Callout Description1 Lock for security cable 3 Cable tie holder2 Grounding point 4 Power supply inputJ-SRX100Device DDR MemoryJ-SRX100B 512 MBJ-SRX100H 1 GBJ-SRX100S 1 GBJ-SRX100SU 1 GB