Dell PowerConnect M8428-k Manual

Also see for PowerEdge M420: Manual Command reference guide Owner's manual Administrator's guide Information update

Contents

Dell PowerConnect M8428-k Manual Manual pdf 14 page image

Software User’s ManualRev 1.00143.3 CLI Command Reference ConventionsThis section describes the PTM CLI commands.For each command, the following information is provided:• Synopsys:Lists the command name and any required or optional parameters. Variable parameters (like portnumbers) are shown in italics. Optional parameters are shown in square brackets, e.g.[optional_parameter]. Required parameters are shown with no brackets.• Description:Provides a detailed description of the command and of all its parameters• Example:Usage example and command output.• For purpose of automation, the symbol ‘#’ is used to indicate a comment that extends until thenext new-line character.3.4 General Commands3.4.1 helpSynopsys:helpset port test Sets port test mode attributes Section 3.7.1, “set port test(ADMIN),” on page 18show port link Shows port link state Section 3.7.2, “show port link,” onpage 18show port module Shows uplink module parameters Section 3.7.3, “show port module,” onpage 19show port test Shows ports test mode status Section 3.7.4, “show port test(ADMIN),” on page 20Debug Commandscr_read To read a 32 bit register from device num-ber device_num. Section 3.8.1, “cr_read (ADMIN),” onpage 20cr_write To write a data_dword to address0xHex_address to device numberdevice_num.Section 3.8.2, “cr_write (ADMIN),”on page 20Table 5 - List of CommandsCommandname Short Description Reference