Dell PowerConnect M8428-k Release Notes

Also see for PowerEdge M420: Manual Command reference guide Owner's manual Administrator's guide Information update

Contents

Dell PowerConnect M8428-k Release Notes Manual pdf 17 page image

PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release NotesSystem Firmware Version 4.1.0.6 Page 15 Dynamic VLAN AssignmentDynamic VLAN assignment is intended to support the connection of hosts to a router with enhanced levels of service,typically either security or QoS. This release supports dynamic VLAN assignment as assigned from the RADIUSserver as part of port authentication. The following additional checks are performed in support of dynamic VLANassignment:Before assigning the port to RADIUS assigned VLAN, dot1x checks if the given VLAN is in the VLAN database ornot. If the assigned VLAN is not in the VLAN database and dynamic VLAN assignment is enabled, a VLAN is createdon the port over which the client is authenticated. Each time a client is de-authenticated on an interface with a particularVLAN, a check verifies if there any other interface which is a VLAN member. If there is no interface as a member, theVLAN is deleted. This behavior is same for MAC based authentication as well. Usability EnhancementsIn the output of the show running-config command, the slot and member configuration is commented with theswitch/slot type in human comprehensible form.When in interface config mode, CLI users can navigate to a different interface by entering the appropriate interfacecommand without leaving interface config mode.CLI users can log out of the switch using the exit command (exit is an alias for quit).The CLI Reference Guide is updated with acceptable character sets and maximum lengths for string parameters tocommands.Management ACLs permit specification of service any as shorthand for enabling all services access for in-bandmanagement.VLANs may be administratively assigned to MSTIs in excess of the switch physical limits and without regard towhether the VLAN is actually configured. Frames are only forwarded on VLANs assigned to interfaces.Administrators can re-enter SYSLOG server config mode for a particular SYSLOG server entry without requiring thedeletion and re-creation of the entry.Administrators can configure the web timeout by navigating to: System -> Management Security -> Telnet Server ->Telnet Session Timeout.User configured banners (login, exec, MOTD) appear in the running config.By default, auto-install supports image downgrade for network installs, specific version USB installs (using a .setupfile), and stack firmware synchronization.A comprehensible message and recommendation is issued when configuring multiple services (telnet, http,…) to listenon the same TCP port.The terminal length command allows user control over terminal paging. Simple ModeThe PowerConnect M8024-k is the only modular switch that defaults to the simple mode of operation. Simple modecontains a restricted set of commands suitable for control of a port aggregation device that can be deployed in anetwork without requiring updates to the network by a network administrator. Users needing switch capabilities whichrequire the network administrator to modify the network configuration can exit simple mode using the no mode simplecommand. AAA AuthenticationIn prior releases, more than one method could be specified for dot1x authentication even though only the first methodwas attempted. The CLI and Web now only accept a single method for dot1x authentication.