Dell PowerConnect W-6000 Installation Manual

Also see for PowerConnect W-6000: Installation guide

Contents

Dell PowerConnect W-6000 Installation Manual Manual pdf 2 page image

2 Dell PowerConnect W-6000 Power Supply | Installation GuidePhysical DescriptionFigure 1 400W Power SupplyModule Fastening Screws: These two captive fastening screws hold the power supply in place in the chassis.Module Handle: This handle is used for removing or inserting the module into the W-6000 chassis.Indicator LEDsAir Intake Vent: This air intake vent helps the internal fan cool the power supply during operation. To preventblockage, keep all material at least 10 cm (4 inches) from the vent.Power Cord Retaining Clip: This clip fits over the power cord once the plug has been inserted into the powerinput socket. It helps prevent the power cord from being pulled out accidentally.Power Input Socket: This power socket accepts power cords with standard IEC320 connectors. For proper safetyand performance, the cord must be rated to 10 A and conform to grounded electrical standards in the countrywhere the product is used.O.T.PDC OKAC OK176541 2 36.5A MAX12CAUTION: Do not use the power supply handle to lift or move the W-6000. Serious damage could result.Table 1 400W Power Supply LEDsLED Name Position Status DescriptionO.T.P.(Over Temp.Protection)Top Off Power supply temperature is okay.Red Power supply fan has failed or temperature is too high.DC OK Middle Green DC power output is okay.Red DC power output is not within tolerance.AC OK Bottom Green AC power input is okay.Red AC power input is not within tolerance.3NOTE: In addition to the LEDs, the power supply status can be viewed using the CLI.45CAUTION: Do not use the power cord retaining clip to remove the power supply module, or to lift or move the W-6000.6