Dell PowerConnect Zeiss 7048 Getting Started Manual

Also see for PowerConnect 7024: Release notes Release note Manual Upgrading Firmware

Contents

Dell PowerConnect Zeiss 7048 Getting Started Manual Manual pdf 16 page image

14 Getting Started GuideInstallationSite PreparationPowerConnect 7000 Series switches can be mounted in a standard 48.26-cm(19-inch) rack or left freestanding (placed on a flat surface) and function asstand-alone switches.Before installing the switch or switches, make sure that the choseninstallation location meets the following site requirements:• Power — The switch is installed near an easily accessible 100–240 VAC,50–60 Hz outlet.• Clearance — There is adequate front and rear clearance for operatoraccess. Allow clearance for cabling, power connections, and ventilation.• Cabling — The cabling is routed to avoid sources of electrical noise suchas radio transmitters, broadcast amplifiers, power lines, and fluorescentlighting fixtures.• Ambient Temperature — The ambient switch operating temperaturerange is 0 to 45ºC (32 to 113ºF) at a relative humidity of up to 95 percent,non-condensing.Unpacking the SwitchPackage ContentsWhen unpacking each switch, make sure that the following items areincluded:• One PowerConnect switch• One AC power cable (two AC power cables for the PowerConnect 7048R)• One RJ-45 to DB-9 female cable• One rack-mount kit for rack installation (two mounting brackets, bolts,and cage nuts)• One set of self-adhesive rubber pads for the free-standing switch (four padsare included)• User Documentation CD