Dell PowerEdge 2410 Installation Manual

Also see for PowerEdge 4220: Installation guide Installation guide Manual Manual Manual

Contents

Dell PowerEdge 2410 Installation Manual Manual pdf 14 page image

12 Installation Guided Lay the door in a safe location with the door’s outer surfacefacing upward.Laying the door flat with the outer surface facing upward helpsprevent damage to its cosmetic coating.e Repeat step a through step d for the left back door.Replacing the Back DoorsTo replace the back doors, perform the steps for removal in reverse.Removing and Replacing the Side PanelsCAUTION: For stand-alone racks, reinstalling the side panels is necessarybefore running systems in the rack to ensure proper cooling within the rack.NOTE: You must remove the lower side panels in order to install the sidestabilizer feet.NOTE: Although removing the side panels is not mandatory for installingsystems in a rack, having the sides open makes it easier to install slide assembliesand support rails and to reverse the direction that the front door opens.Removing the Upper Side Panels1 Push both latches up and swing the bottom end of the panel awayfrom the rack (see Figure 1-4).2 Grasp firmly on each side of the panel.3 Lift the panel upward until the panel lip clears the top of the rack.4 Lay the panel in a safe location with the panel’s outer surface facingupward to help prevent damage to its cosmetic coating.5 Repeat step 1 through step 4 for the other upper side panel.Replacing the Upper Side Panels1 Lift the upper side panel up onto the rack, hooking the panel lip over thetop of the rack (see Figure 1-4).2 Swing the bottom of the panel downward onto the rack.3 Press the panel into the rack until both latches lock into place.