Dell PowerEdge 2410 Manual
Also see for PowerEdge R715: ManualHardware installation instructionsInstallationRack installationUpdate
         | |
Cable Routing Procedures for Dell™ PowerEdge™ R715 SystemsPage 7Section 3: Replacing a Power Supply on a PowerEdge™ R715 System With aCMA3.1 Replacing a Power Supply with a Left-Side Mounted CMA1. If the bottom power supply must be replaced, then remove the tray from underneath the CMAas described in theCMA Installation Instructions provided with the CMA kit. If the top powersupply must be replaced, this step can be skipped.2. Swing the CMA to its service position.3. Disconnect the power cord from the power supply and disengage the strain relief.4. Replace the power supply.5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray (if it wasremoved), and return the CMA to the closed (retracted) position.3.2 Replacing a Power Supply with a Right-Side Mounted CMA1. If the bottom power supply must be replaced, then remove the tray from underneath the CMAas described in theCMA Installation Instructions provided with the CMA kit. If the top powersupply must be replaced, this step can be skipped.2. Swing the CMA to its service position.3. Disconnect the power cord from the power supply and disengage the strain relief.4. Disconnect both CMA attachment housings from the rail as shown in Figure 8.5. While supporting the CMA with one hand, remove and replace the power supply with theother hand as shown in Figure 8.6. Reconnect the CMA attachment housings to the rail.7. Plug in the power cord, re-engage the strain relief, replace the CMA support tray (if it wasremoved), and return the CMA to the closed (retracted) position.Figure 8: Replacing the Power SupplyCMA attachment housingshave been disconnected. |
Related manuals for Dell PowerEdge R715
manualsdatabase
Your AI-powered manual search engine