Dell PowerEdge 2600 Service Manual

Also see for PowerEdge 2600: Manual Information update Installation guide Installing or replacing Update

Contents

Dell PowerEdge 2600 Service Manual Manual pdf 48 page image

Figure 4-28. Removing and Replacing the SCSI Backplane BoardReplacing the SCSI Backplane Board1. Lower the backplane board into the system.2. Align the backplane board onto the board's grounding tabs.3. Slide the backplane board down about 0.5 inch.4. Tighten the thumbscrew on the backplane board.5. Install all SCSI hard drives (see "Installing a Hard Drive").6. Install the SCSI backplane daughter card (see "Installing the SCSI Backplane Daughter Card").7. Insert the SCSI_A cable into the SCSI_A connector on the back of the SCSI backplane board (see Figure 4-28).8. Pull the locking bar to the unlock position to insert the flat cable connector (BKPLN) into the PLANAR CONNECTOR on the back of the SCSI backplaneboard; next, push the locking bar to lock the flat cable into the connector (see Figure 4-28).9. Insert the 14-conductor power cable into the SCSI BACKPLANE POWER connector on the back of the SCSI backplane board (see Figure 4-28).10. Insert the 4-conductor power cable into the 1 x 2 POWER connector on the back of the SCSI backplane board (see Figure 4-28).11. Insert the front fan cable into the P1 connector on the front of the SCSI backplane board.12. Replace the cover (see "Replacing the Cover").13. Reconnect your system and peripherals to their electrical outlets, and turn on the system.Memory ModulesThe six memory module connectors on the system board can accommodate a minimum of 256 MB of registered memory modules. The memory moduleconnectors are arranged in pairs which consist of three banks (bank 1, bank 2, and bank 3).Memory Upgrade KitsThe system is upgradable by installing combinations of 128-, 256-, 512-MB, or 1-GB registered DDR SDRAM modules. You can purchase memory upgrade kits asneeded.CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Seeyour System Information Guide for complete information about safety precautions, working inside the computer, and protecting againstelectrostatic discharge.NOTICE: To avoid damage to the system, align the bottom of the backplane board in the board's mounting grooves before rotating the top of the boardonto the grounding tabs (see Figure 4-28).NOTICE: The memory modules must be PC-2100 compliant.